BEP Programming Tool for Ultrasonic Tank Sender

The BEP ultrasonic tank sensor uses ultrasonic waves to measure the level in a fuel, water or wastewater tank.
No moving parts, so there is no risk of malfunctions.
The tank sender can convert this ultrasonic signal into a 240-33 Ohm, 10-180 Ohm and Vetus 10-300 (analog) volt signal, allowing it to be read with standard analog instruments.
The tank sender has a standard SAE 5-hole pattern and can therefore replace an existing tank sender.
Suitable for plastic and metal tanks.
The sensor should be installed on top of the tank.

- Mfr. no.- TS1-PK
- Description Ultrasonic tank sensor programming tool

• compact design 95 x 19 mm
• SAE 5-hole pattern
• suitable for a depth of 2000 mm
• voltage 10 -32V
• current consumption 25 mA with 5-volt device output
• 2mm accuracy
• ambient temperature: 4°C to 65°C
• resistant to gasoline, diesel, water and toilet chemicals

The optional intuitive software allows the
ultrasonic tank sensor to be calibrated very precisely
by entering the exact dimensions of the tank.